|
Ecotek
May 22, 2005 2:35:58 GMT -5
Post by eazzzyskif on May 22, 2005 2:35:58 GMT -5
Hi guys,
Has anyone fitted an ecotek valve to a 1.4 8v? if you have can someone please please email me a picture of where it goes. The picture in the know your car section isnt to clear...
k1fy@yahoo.co.uk cheers
|
|
206rallye
loves it here
Dodge this Viper! :)
Posts: 92
|
Ecotek
May 22, 2005 5:32:09 GMT -5
Post by 206rallye on May 22, 2005 5:32:09 GMT -5
from what i understand it attachs to the brake servo pipe? personally i wouldn't fancy cutting into any of my pipes for something which isn't very proven on saving fuel.
|
|
|
Ecotek
May 22, 2005 5:47:24 GMT -5
Post by chi_chee on May 22, 2005 5:47:24 GMT -5
|
|
|
Ecotek
May 22, 2005 14:14:53 GMT -5
Post by LeeXS on May 22, 2005 14:14:53 GMT -5
Hey I got one!! The brake servo is located behind the battery area - its a black circular disk!! The pipe leads from here to your left (towards the drivers side) and then connects near the throttle cable. But I went to my local garage, they gave me some servo pipe and two silver clamps that you screw to tighten!! I then pulled the cable off at the servo and attached it!! Hope this helps!!
I will try and source you a pic!!
|
|