|
|
Post by Jimmy on Feb 25, 2005 18:51:50 GMT -5
The place that did all my stuff lowered my 206 oin the rear by 1 spline ive heard this is bad and just wanted some reasonign before i go back and complain and also how they can do it so it wont rub?
|
|
|
|
Post by teddy on Feb 26, 2005 4:18:21 GMT -5
Using the spline method restricts the drop to set levels. Removing the arms from the axle also risks damaging the bearings.
Leaving the arms in place and removing the torsion bars literally means you can have exactly (within 2mm ish) the drop you want...
I can't see the point in using the spline method. It doesn't seem to be any easier so has no advanatges at all.
|
|
|
|
Post by Jimmy on May 5, 2005 6:09:34 GMT -5
All sorted wasnt that they lowered it to much apparently it was a piece of pertruding plastic apparently muppets
|
|
